New detector breakthrough pushes boundaries of quantum computing

Measuring the energy of qubits is at the heart of how quantum computers operate. Most quantum computers currently measure a qubit’s energy state by measuring the voltage induced by the qubit. However, there are three problems with voltage measurements: firstly, measuring the voltage requires extensive amplification circuitry, which may limit the scalability of the quantum computer; secondly, this circuitry consumes a lot of power; and thirdly, the voltage measurements carry quantum noise which introduces errors in the qubit readout. Quantum computer researchers hope that by using bolometers to measure qubit energy, they can overcome all of these complications, and now Professor Möttönen’s team have developed one that is fast enough and sensitive enough for the job.

‘Bolometers are now entering the field of quantum technology and perhaps their first application could be in reading out the quantum information from qubits. The bolometer speed and accuracy seems now right for it,’ says Professor Möttönen.

The team had previously produced a bolometer made of a gold-palladium alloy with unparalleled low noise levels in its measurements, but it was still too slow to measure qubits in quantum computers. The breakthrough in this new work was achieved by swapping from making the bolometer out of gold-palladium alloys to making them out of graphene. To do this, they collaborated with Professor Pertti Hakonen’s NANO group – also at Aalto University – who have expertise in fabricating graphene-based devices. Graphene has a very low heat capacity, which means that it is possible to detect very small changes in its energy quickly. It is this speed in detecting the energy differences that makes it perfect for a bolometer with applications in measuring qubits and other experimental quantum systems. By swapping to graphene, the researchers have produced a bolometer that can make measurements in well below a microsecond, as fast as the technology currently used to measure qubits.

‘Changing to graphene increased the detector speed by 100 times, while the noise level remained the same. After these initial results, there is still a lot of optimisation we can do to make the device even better,’ says Professor Hakonen.

Now that the new bolometers can compete when it comes to speed, the hope is to utilise the other advantages bolometers have in quantum technology. While the bolometers reported in the current work performs on par with the current state-of-the-art voltage measurements, future bolometers have the potential to outperform them. Current technology is limited by Heisenberg’s uncertainty principle: voltage measurements will always have quantum noise, but bolometers do not. This higher theoretical accuracy, combined with the lower energy demands and smaller size – the graphene flake could fit comfortably inside a single bacterium – means that bolometers are an exciting new device concept for quantum computing.

The next steps for their research is to resolve the smallest energy packets ever observed using bolometers in real-time and to use the bolometer to measure the quantum properties of microwave photons, which not only have exciting applications in quantum technologies such as computing and communications, but also in fundamental understanding of quantum physics.

Many of the scientists involved in the researchers also work at IQM, a spin-out of Aalto University developing technology for quantum computers. “IQM is constantly looking for new ways to enhance its quantum-computer technology and this new bolometer certainly fits the bill,” explains Dr Kuan Yen Tan, Co-Founder of IQM who was also involved in the research.

The research collaboration is part of the Center of Excellence in Quantum Technology (QTF) and the BOLOSE sensor development project (RADDESS program, 2018-2021) funded by the Academy of Finland. Professor Möttönen's team is also part of the Horizon 2020 funded QMICS project, part of the EU commission’s Quantum Flagship.

The work was carried out using the OtaNano research infrastructure. OtaNano provides state-of-the-art working environment and equipment for nanoscience and -technology, and quantum technologies research in Finland. OtaNano is operated by Aalto University and VTT, and is available for academic and commercial users internationally. To find out more, visit their website.

More Information

Full Paper

R. Kokkoniemi, J.-P. Girard, D. Hazra, A. Laitinen, J. Govenius, R. E. Lake, I. Sallinen, V. Vesterinen, P. Hakonen, and M. Möttönen, Bolometer  operating  at  the  threshold  for  circuit  quantum electrodynamics, Nature, https://doi.org/10.1038/s41586-020-2753-3 (2020).
 

Contact Details

Mikko Möttönen
Professor
Aalto University and  VTT
mikko.mottonen@aalto.fi

Pertti Hakonen
Professor
Aalto University
pertti.hakonen@aalto.fi

Read Mikko Möttönen’s blog: Our quantum breakthrough wins international acclaim (VTT)