News

Life on the edge in the quantum world - Taking shortcuts and driving at the quantum speed limit

Pulling off high-speed energy transfers in the lab gives researchers insight into quantum computing, high-speed rechargeable batteries, and other future applications of quantum technology.
Superadibiatic transfer QTF

Quantum physics sets the laws that dominate the universe at the very small scale. The ability to harness quantum phenomena will hopefully allow us to build machines like quantum computers, which are predicted to perform certain calculations much faster than conventional computers. One major problem with building quantum processors is that the ability to track and control quantum systems in real-time is an overwhelmingly fragile task: if we try to manipulate these systems carelessly, significant errors get introduced in the final result. New work by a team at Aalto hopefully means we can carry out these delicate operations as quickly as possible.

To get to this point, the researchers controlled quantum phenomena in a custom-designed electrical circuit called a transmon (see Figure). When we chill a transmon chip to within a few thousandths of a degree above absolute zero, the device enters the quantum world, and starts to behave like an artificial atom. One of the quantum features that interests researchers is that the energy of the transmon can only take specific values, called energy levels. The energy levels are like steps on a ladder: a person climbing the ladder has to stop on a step, and can’t hover somewhere in-between two steps. Likewise, the energy the transmon has can only can only be the set values of the energy levels. When we shine microwaves on the circuit, the transmon can absorb the energy and climb up the rungs of the ladder.

In work published 8February in the journal Science Advances, a group from Aalto University led by Docent Sorin Paraoanu, Senior University Lecturer in the Department of Applied Physics, has been able to make the transmon jump more than one energy level in one go. Previously, this has been possible only by very gentle and slow adjustments of the microwave signals that control the device. In the new work, an additional microwave control signal shaped in a very specific way allows a very precise and fast change of the energy level. Dr. Antti Vepsäläinen, the lead author, explains: ‘We have a saying in Finland: “hiljaa hyvää tulee” (slowly does it). But we managed to show that by correcting continuously the state of the system, we can drive this process more rapidly and at high fidelity.

transmon
Superconducting circuits comprising a transmon device can be used for quantum state control - Paraoanu group/Aalto University. Image by Dong Lan and Sorin Paraoanu.

Dr. Sergey Danilin, one of the coauthors, describes quantum control – the process of using chips like transmons to build quantum computers – by extending the “climbing a ladder” analogy. ‘To get a useful quantum system, you need to imagine climbing a ladder while holding a glass of water, it  works if one does it smoothly –  but if you do it too fast the water will be spilled. Certainly this requires a special skill.’ The researchers found that in the quantum word the trick for climbing the ladder quickly without spilling any water is by carefully jumping two rungs at a time! This short-cut up the energy ladder was achieved by making the transmon absorb two different microwave photons at the same time. The laws of nature put a restriction on how fast any quantum energy switch can take place, even with short-cuts and this restriction is called the quantum speed limit. To their delight, the Aalto scientists found that their new method resulted in changes to the energy level that took place at speeds that were close to this theoretically calculated limit.

The wider impact of being able to control high speed energy transfers in quantum systems are also exciting to the team. Of potentially high importance are quantum computing and quantum simulation applications, which requires fast and highly robust operations such as state preparation and the creation of quantum gates. Dr. Paraoanu sees opportunities developing in other directions as well: ‘We would like to understand more deeply the processes related to energy transfer, which are ubiquitous in the natural world and in the technological marvels that surround us. For example, are there any fundamental limits to how fast we can charge the battery of an electric car?’ In the rapidly-developing field of quantum technologies, it is possible that this new control method will find multiple applications.

 

Full Reference:
A. Vepsäläinen, S.Danilin, and G.S. Paraoanu "Superadiabatic population 
transfer in a three-level superconducting circuit"
Science Advances 5, eaau5999 (2019).
DOI: 10.1126/sciadv.aau5999

Note to editors:
The research team is part of the national centre of excellence – Quantum Technology Finland, funded by the Academy of Finland. The experimental research was carried out at the national OtaNano research infrastructure for micro, nano, and quantum technologies.

  • Published:
  • Updated:
Share
URL copied!

Related news

Aalto University
Research & Art Published:

Installation Talks of seven new tenured professors of the School of Engineering

Our new Associate & Full level tenure track professors tell us about their research on short videos.
Smart City Challenge
Research & Art Published:

Four smart city pilot projects start in January 2021

Altogether 71 ideas were proposed to the international challenge for smart cities. 
ARTS open science roadshow, pic of the session
Research & Art Published:

European Open Science Cloud (EOSC) Finnish Forum webinar on 25th January

One of the speakers is Karel Luyben, the first president of the EOSC Association and a member of board at Aalto University.
Installation Talk 2020, Jarkko Niiranen
Research & Art Published:

Professor Jarkko Niiranen on the computational mechanics of microarchitectural solids and structures

'When developing models, we spend a lot of time on mathematical physics, numerical mathematics and computer programming, but the fundamental concepts of mechanics remain the same' says Niiranen in his installation talk.