Bio2 - Water analysis

We have a wide selection of equipment for determining the quality and properties of raw, process or wastewater:

pH,  conductivity, redox-potential,

colour, turbidity,

alkalinity, water hardness,

total nitrogen, ammonium-, nitrate-, phosphorus,

biochemical oxygen demand (BOD),  chemical oxygen demand (COD), total organic carbon (TOC),

suspended solids, dissolved solids and ash content,

total chlorine, AOX,

toxicity of water using luminescent bacteria.

Bio2 / Water analysis

Methane Potential Test System (AMPTS) II determines the biochemical methane potential and dynamic profile of any biomass substrate. AMPTS II is an analytical device developed for on-line measurements of ultra-low biomethane and biogas flows produced from the anaerobic digestion of any biological degradable substrate at a laboratory scale. A multichannel analyser consisting of 15 parallel reactors and the same number of gas flow meters is attached to a data acquisition system.

We have also developed and built certain operational department scale activated sludge treatment systems, one of which is portable.

This service is provided by:

Department of Bioproducts and Biosystems

Did you find what you were looking for? If not, please contact us.
  • Published:
  • Updated:
URL copied!